Safety
viii 975-0004-01-02 Rev D
Battery Safety Information
• Always wear eye protection, such as safety glasses, when
working with batteries.
• Remove all jewelry before working with batteries.
• Never work alone. Have someone assist you with the
installation or be close enough to come to your aid when
working with batteries.
• Always use proper lifting techniques when handling
batteries.
• Always use identical types of batteries.
• Never install old or untested batteries. Check each
battery’s date code or label to ensure age and type.
• Batteries should be installed in a well-vented area to
prevent the possible buildup of explosive gasses. If the
batteries are installed inside an enclosure, vent its highest
point to the outdoors.
• When installing batteries, allow at least 1 inch of air
space between batteries to promote cooling and
ventilation.
• NEVER smoke in the vicinity of a battery or generator.
• Always connect the batteries first, then connect the
cables to the inverter or controller. This will greatly
reduce the chance of spark in the vicinity of the batteries.
• Use insulated tools when working with batteries.
• When connecting batteries, always verify proper voltage
and polarity.
• Do not short-circuit battery cables. Fire or explosion can
occur.
• In the event of exposure to battery electrolyte, wash the
area with soap and water. If acid enters the eyes, flood
them with running cold water for at least 15 minutes and
get immediate medical attention.
• Always recycle old batteries. Contact your local
recycling center for proper disposal information.
To Next Page
Loading...
Need help?
General
