XCell ATF Series - Page 37

33
XCell
TM
ATF System with C410:V3 Controller
User Guide
Analog Input Configuration / Calibration: Only accessible to the Administrator and Engineer
Login. The Analog Input Configuration / Calibration screen allows for the setup of analog
inputs.
For each analog input the Administrator and Engineer will be able to configure the Engineering
Units, the Minimum Engineering Value, the Maximum Engineering Value, and perform a two
point calibration.
Note: this should only be performed by a qualified metrology personal or Repligen Field Service Engineer.
The Calibration screen will display parameters in the following tables:
Field
Description
Engineering Units
Enter the Engineering Units for the selected analog input
Minimum
Engineering Value
Enter the Minimum Engineering Value for the selected analog input
Maximum
Engineering Value
Enter the Maximum Engineering Value for the selected analog input
Calibration Point #1
Enter the first calibration point in Engineering Units in the range of
Minimum Engineering Unit to Maximum Engineering Unit
Calibration Point #2
Enter the second calibration point in Engineering Units in the range of
Minimum Engineering Unit to Maximum Engineering Unit
C.5
CALIBRATION