To Next Page

To Previous Page

SETTING UP THE FIERY EXP4110 FROM THE CONTROL PANEL

IP Address

[127.0.0.1]

Enter the Fiery EXP4110 IP address for Ethernet. This IP address, unlike an IP address set

automatically, remains the same if you restart the Fiery EXP4110. You must change the

default to a valid address for your network. For information about setting up printing with

TCP/IP, see page 12.

Subnet Mask

This option lets you modify the subnet mask for printing with TCP/IP over Ethernet.

NOTE: Conﬁrm the subnet mask setting with your network administrator before proceeding.

In some cases, the required setting may be different from that listed.

Gateway Address

[127.0.0.1]

This option appears only if you answered No to Get Gateway Address Automatically.

Use this option to set the gateway address for printing with TCP/IP. If your network uses a

gateway, you must change the default to a correct gateway address for your network.

DNS Setup

You can conﬁgure the Fiery EXP4110 so that it can access an appropriate DNS server. With

the DNS server, when connecting the utilities or WebTools from remote workstations to the

Fiery EXP4110, users need to remember only its Server Name, which is easier to remember

than an IP address.

Get DNS Address Automatically

Yes/No [Yes]

Select Yes to get the DNS address automatically. If you select No, you proceed to the Primary

DNS Server IP Address option, where you manually set the IP address.

Primary DNS Server

IP Address

0.0.0.0

This option appears only if you have selected No to Get DNS Automatically. Specify the IP

address of the primary DNS server.

Network Setup

Protocol Setup

TCP/IP Setup

DNS Setup

Xerox 4110 Configuration And Setup

Other manuals for Xerox 4110