SETTING UP THE FIERY EXP4110 FROM THE CONTROL PANEL
37
Secondary DNS Server
IP Address
0.0.0.0
Specify the IP address of the secondary DNS server.
Domain Name
Enter the DNS domain name.
Host Name
Enter the DNS host name of the Fiery EXP4110. This option is available only if you set Get
DNS Address Automatically to No.
Security Setup options
IP Filtering and IP Port Setup options are available in Security Setup.
Using IP Filtering options, you can set controlled access to the Fiery EXP4110 by specifying
IP addresses that the Fiery EXP4110 permits or rejects receiving. This prevents unlimited
access to the Fiery EXP4110 over your network and ensures network security in your
environment.
Using IP Port Setup options, you can close unnecessary ports and help reject inbound access
from the network.
IP Filtering
By default, the Fiery EXP4110 permits all IP addresses. To control access, you can set an IP
address or a range of IP addresses.
Enable IP Filter
Yes/No [No]
Select Yes to allow the Fiery EXP4110 to proceed to the subsequent IP filtering settings.
Default Policy
Accept/Deny [Accept]
Select Accept to accept IP addresses other than the IP addresses you specify at this Setup.
Select Deny to reject IP addresses other than the IP addresses you specify at this Setup.
Add Entry
IP Address/IP Range [IP Address]
Select IP Address to permit or reject individual IP addresses. Select IP Range to specify a range
of IP addresses to be permitted or rejected. Up to 16 IP addresses can be specified.
NOTE: Do not enter “0.0.0.0” or “255.255.255.255”.
Delete Entry
Yes/No [No]
This option allows you to delete IP addresses individually or by range.
To Next Page
Loading...
Need help?
General