To Next Page

To Previous Page

SETTING UP THE FIERY EXP4110 FROM THE CONTROL PANEL

FTP Printing

Enable FTP Printing

Yes/No [Yes]

Select Yes to enable FTP printing on the Fiery EXP4110.

Require Password for Printing

Yes/No [No]

Select Yes to specify a user password for FTP printing. From the Fiery EXP4110 Control

Panel, you can enter a maximum of 31 ASCII characters (no spaces in between) for the

password. This setting is available when you add a new user for FTP printing. By default, no

password is set for FTP printing. We recommend that you set one for security reasons.

Timeout (sec)

10-300 [30]

Specify the timeout. After you have ﬁnished making the selection, restart the Fiery EXP4110

for the settings to take effect. To conﬁrm the settings, print a Conﬁguration page.

SNMP Setup

Enable SNMP

Yes/No [Yes]

Select Yes to enable SNMP. This option enables SNMP communication over a TCP/IP or IPX

connection.

SNMP Read Community Name, SNMP Community Name

[public]

You can change the SNMP Community Name “public,” which is used for reading and

writing. When it is changed, the new community name must be entered to read and write any

information in remote Setup. A maximum of 32 ASCII characters including spaces can be

used for the community name.

NOTE: A space at the beginning or end of the name is automatically deleted from the name

entered. When an invalid character is entered or no name is speciﬁed, the default “public” is

used for the community name. A name consisting only of spaces is invalid.

Network Setup

Service Setup

SNMP Setup

Xerox 4110 Configuration And Setup

Other manuals for Xerox 4110