To Next Page

To Previous Page

SETTING UP THE FIERY EXP4110 FROM A NETWORK COMPUTER

PServer Poll Interval

Specify the polling interval (in seconds) for NetWare printing.

LPD Printing

Enable LPD Printing Service enables or disables LPD printing services.

Windows print sharing with Server Message Block (SMB)

Enable Windows Printing Service enables SMB (Server Message Block), the ﬁle and printer

sharing protocol built into Windows. Enabling SMB lists the Fiery EXP4110 on the network

so that Windows clients can print to a particular print connection (Hold, Print, or Direct) on

the Fiery EXP4110 without any other networking software. For information about setting up

a Windows computer for Windows printing, see Printing from Windows.

NOTE: Windows (SMB) printing runs over TCP/IP. You must conﬁgure TCP/IP on the

Fiery EXP4110 and any computers that use Windows printing.

Server Name allows you to assign the server name that will appear on the network. Use the

same name as the server name assigned to the Fiery EXP4110 (see page 61), or choose

another name.

Comment allows you to type information about the printer. These comments are listed in the

Properties of the Fiery EXP4110 in Network Neighborhood.

Domain or Workgroup allows you to assign the workgroup or domain where the

Fiery EXP4110 should appear.

Auto IP speciﬁes whether to allow the Fiery to obtain the IP address automatically for the

WINS Name Server if you have already enabled IP Auto in Protocol Setup, and selected either

DHCP or BOOTP as the protocol for obtaining an IP address. If you do not select this

option, use the following two options to specify whether to use a WINS Name Server and its

IP address.

Use WINS Server speciﬁes whether to use a WINS name server. Broadcasts from SMB devices

cannot be routed beyond their original network segment without a WINS name server.

Setting up the WINS name server is outside the scope of this document. To ﬁnd out if a name

server is available, contact your network administrator.

IP Address allows you to assign the IP address of the WINS name server.

NOTE: After setting up the WINS name server settings, turn off and on the printer for the

settings to take effect. Make sure the status message on Command WorkStation reads Idle

when you turn off and on the printer.

Xerox 4110 Configuration And Setup

Other manuals for Xerox 4110