Configuring the Smart Card
After the Smart Card feature is enabled on the device, you can use Internet Services to configure the
Smart Card.
Configure Smart Card Authentication
To enable and configure the Smart Card:
1. In the Internet Services Login/Permissions/Accounting menu, click Login Methods.
2. Enter the Domain Controller details for the authentication server.
a. Click Domain Controllers – Edit from the Configuration Settings list.
Note
Initially the Domain Controllers are empty and the NTP server is not set.
b. Click Add Domain Controller.
c. Select the Windows Based Domain Controller check box. Or, to select the Linux-Based Domain
Controller, clear the check box.
Xerox
®
AltaLink
®
Series3-10
Smart Card Installation and Configuration Guide
Installation
To Next Page
Loading...
