Xerox DocuMate 152 User Manual

DocuMate 152 Scanner User’s Guide 13
Installation
Step 3: Connect the Power Supply
Connect the power supply and power cord, and plug the power
supply into an electrical outlet.
To connect your Xerox DocuMate 152 scanner:
1. Plug the power supply into the power port on the scanner.
2. Plug the power cord into the power supply and into a wall
outlet.
Now proceed to the next section, “Step 4: Connect the USB
Cable and Turn on the Power.”
NOTE: Only use the power supply (HEG42-240200-7L made by
HiTron) included with your scanner. Connecting any other type
of power supply may damage your scanner, and will void its
warranty.

Xerox DocuMate 152 Specifications

General

Film scanning	No
Color scanning	Yes
Grayscale levels	65536
Input color depth	24 bit
Maximum scan size	216 x 356 mm
Optical scanning resolution	600 x 1200 DPI
Flatbed scan speed (b/w, A4)	0.25 sec/page
Scanner type	Sheet-fed scanner
Product color	Gray
Sensor type	CCD
Daily duty cycle (max)	30000 pages
ISO A-series sizes (A0...A9)	A4
Auto document feeder (ADF) input capacity	50 sheets
USB version	2.0
Standard interfaces	USB 2.0
Minimum RAM	512 MB
Minimum storage drive space	350 MB
Power supply type	-
Power consumption (standby)	6 W
Power consumption (typical)	30 W
Operating temperature (T-T)	10 - 35 °C
Package width	251.459 mm
Package height	253.999 mm
Package weight	4808.1 g

Weight and Dimensions

Depth	160 mm
Width	309 mm
Height	141 mm
Weight	2700 g