Xerox DocuMate 152 User Manual

Scanning with the TWAIN Interface from PaperPort
92 DocuMate 152 Scanner User’s Guide
Setting Up PaperPort to Work with Your Scanner
When you select a scanning option from the Scanner drop-down
list, either TWAIN: Xerox DocuMate 152 or WIA: Xerox
DocuMate 152 (Windows XP and Windows Vista only), the Scan
button at the bottom of the panel should become active. If it doesn’t
you need to set up PaperPort to work with your scanner.
NOTE: Setting up PaperPort is a one-time-only process for
each option from the Scanner drop-down list. Therefore, you
may have to set up PaperPort once each for TWAIN: Xerox
DocuMate 152 and WIA: Xerox DocuMate 152. The setup
process, described below, is the same for each option. You will
not have to set up PaperPort again for either option unless you
uninstall the scanner and PaperPort software, then re-install
them.
If this Scan button is not active,
you need to setup your scanner.

Xerox DocuMate 152 Specifications

General

Film scanning	No
Color scanning	Yes
Grayscale levels	65536
Input color depth	24 bit
Maximum scan size	216 x 356 mm
Optical scanning resolution	600 x 1200 DPI
Flatbed scan speed (b/w, A4)	0.25 sec/page
Scanner type	Sheet-fed scanner
Product color	Gray
Sensor type	CCD
Daily duty cycle (max)	30000 pages
ISO A-series sizes (A0...A9)	A4
Auto document feeder (ADF) input capacity	50 sheets
USB version	2.0
Standard interfaces	USB 2.0
Minimum RAM	512 MB
Minimum storage drive space	350 MB
Power supply type	-
Power consumption (standby)	6 W
Power consumption (typical)	30 W
Operating temperature (T-T)	10 - 35 °C
Package width	251.459 mm
Package height	253.999 mm
Package weight	4808.1 g

Weight and Dimensions

Depth	160 mm
Width	309 mm
Height	141 mm
Weight	2700 g