Xerox DocuMate 4830
User’s Guide
166
There are some features in the scanner interface that are disabled until a module is installed that contains those
options. When the module is installed, the features will enable in the scanner interface for you to use them.
Reordering the Modules
Select a module in the list and click the up or down arrow to change the order of the module in the list. Changing the
order of the modules changes the order in which the image processing options are used. For example, if there are
two modules installed and both modules include an automatic image rotation option, the first module's rotate
option is used and the rotate setting in the second module is ignored so that the image is not rotated twice.
Scanner Configuration
The scanner configuration tab shows the hardware information for your scanner.
Power adjustments:
• Power save—power save mode is the low-power state when the scanner is not in use. Click the up or down
arrows to adjust the amount of time, in minutes, after scanning is complete before the scanner enters the low
power state. You can also type a number directly in the box.
Click the green apply button to save the changes made to the power save time-out.
Click the red reset button to return the power save time-out to the default setting.
• Turn lamp on and Turn lamp off—click either of these buttons to immediately turn the scanner lamp on or
off.
• Reset device—click this button to revert the scanner hardware back to the scanner’s firmware defaults. As this
option resets the scanner hardware, you will not see a change in the interface unless the power save time has
been changed. Clicking this button includes returning the power save time-out to the default setting.
Scanner maintenance:
• Counters—click the reset button next to the counter you want to set back to 0. You can use this option to
monitor the number of scans completed since the last time a part has been replaced.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
