Xerox DocuMate 4830 User Manual

Xerox DocuMate 4830
User’s Guide
178
Replacing the ADF Pad Assembly
The ADF pad may wear out and is designed to be a user-replaceable part. Problems with
documents feeding into the ADF is an indication that the pad is wearing out.
Discard the parts as you remove them from the scanner, the parts cannot be reused and are a
choking hazard.
1. Open the ADF cover. The ADF pad is located on the top of the duplex lamp module.
2. Squeeze the plastic clamp that holds the pad assembly in place.
3. Lift the pad up and out of the scanner.
4. Remove the tension spring that is located under the ADF pad.

Xerox DocuMate 4830 Specifications

General

Film scanning	-
Color scanning	Yes
Maximum scan size	297 x 2997 mm
Output color depth	24 bit
ADF scan speed (b/w, A4)	50 ppm
ADF scan speed (color, A4)	30 ppm
Optical scanning resolution	600 x 600 DPI
Duplex ADF scan speed (b/w, A4)	100 ipm
Duplex ADF scan speed (color, A4)	60 ipm
Scanner type	Flatbed & ADF scanner
Product color	Blue, Grey
Built-in display	No
Sensor type	CIS
Scan drivers	ISIS, TWAIN, WIA
Daily duty cycle (max)	3000 pages
Auto document feeder (ADF) input capacity	75 sheets
Maximum ISO A-series paper size	A3
Auto Document Feeder (ADF) media weight	75 - 80 g/m²
USB version	2.0
Standard interfaces	USB 2.0
Input voltage	100-240 V
Power supply type	AC
Power consumption (standby)	15 W
Power consumption (typical)	30 W
Minimum RAM	2048 MB
Minimum storage drive space	350 MB
Cables included	AC, USB
Harmonized System (HS) code	84716070

Weight and Dimensions

Depth	499 mm
Width	581 mm
Height	194 mm
Weight	12000 g