About this printer
2 - 16
2
5 Using both hands, put one piece of paper or one
envelope in the manual feed slot until the front edge of
the paper or envelope touches the paper feed roller.
When you feel the machine pull in the paper, let go.
Note
• Put the paper into the manual feed slot with the side to be printed face up.
• Make sure that the paper or the envelope is straight and in the proper position in the manual feed slot.
If it is not, the paper or envelope may not be fed properly, resulting in a skewed printout or a paper jam.
• Do not put more than one piece of paper or one envelope in the manual feed slot at any one time, as
it may cause a jam.
• If you put any Media (paper, envelope and so on) in the manual feed slot before the printer is in the
Ready state, the media may be ejected without being printed on.
6 After the printed page comes out of the printer, put in the next sheet of paper or the envelope as in Step
5 above. Repeat for each page that you want to print.
Note
• Envelope joints that are sealed by the manufacturer should be secure.
• All sides of the envelope should be properly folded without wrinkles or creases.
• Remove each sheet or envelope immediately after printing. Stacking the sheets or envelopes may
cause the paper to jam or curl.
To Next Page
Loading...
Need help?
General