321 Using the Operator Panel Menus and Keypad
NOTE:
• This item is displayed only when the printer is connected with a wireless network.
• Reset Wireless (DocuPrint M205 fw Only)
Purpose:
To initialize wireless network settings. After executing this function and rebooting the printer, all
wireless network settings are reset to their factory default values.
Values:
NOTE:
• This item is displayed only when the printer is connected with a wireless network.
•TCP/IP
Purpose:
To configure TCP/IP settings. The change becomes effective after the printer is turned off and then on.
Values:
NOTE:
• To configure the IPv6 settings, use CentreWare Internet Services.
WPS Push Button
Control
PBC Start No* Disables the security method of
WPS-PBC.
Yes Configures the wireless setting
with the security method of WPS-
PBC.
PIN Code Start
Configuration
Configures the wireless setting using the PIN code
assigned automatically by the printer.
Print PIN Code Prints the PIN code. Confirm it when you enter the
PIN code to your computer.
No* Does not reset the wireless setting.
Yes Resets the wireless setting.
IP Mode Dual Stack* Uses both IPv4 and IPv6 to set the IP address.
IPv4 Uses IPv4 to set the IP address.
IPv4 Get IP
Address
Auto IP* Automatically sets the IP address.
BOOTP Uses BOOTP to set the IP address.
RARP Uses RARP to set the IP address.
DHCP Uses DHCP to set the IP address.
Panel Enables the IP address entered on the operator
panel.
IP Address Manually sets the IP address allocated to the
printer.
Subnet Mask Manually sets the subnet mask.
Gateway Address Manually sets the gateway address.
To Next Page
Loading...
