Using the Operator Panel Menus and Keypad 332
• mm / inch
Purpose:
To specify the measurement unit displayed after the numeric value on the operator panel.
Values:
• Low Toner Alert Msg
Purpose:
To specify whether to show the alert message when the toner is low.
Values:
• Power On Wizard
Purpose:
To perform initial settings for the printer.
See also:
• "Setting Initial Settings on the Operator Panel" on page 48
Values:
Job Tone Off Does not emit a tone when a job is complete.
Low Emits a tone at the specified volume when a job is complete.
Medium*
High
Alert Tone Off Does not emit a tone when a problem occurs.
Low Emits a tone at the specified volume when a problem occurs.
Medium*
High
All Tones Off Disables all the alert tones.
Low Sets the volume of all the alert tones at once.
Medium
High
Millimeters (mm)* Specifies the default measurement unit.
Inches (")
Off Does not show the alert message when the toner is low.
On* Shows the alert message when the toner is low.
Yes Performs the initial settings for the printer.
No* Does not perform the initial settings for the printer.
To Next Page
Loading...
Need help?
General