Overview
Xerox® Phaser® 3052/3260
User Guide
131
Avoiding Paper Jams
If these guidelines are followed, most paper jams can be avoided.
• Ensure that the adjustable guides on the paper tray are positioned correctly.
• Do not overload the tray. Ensure that the paper level is below the paper capacity mark on the
inside of the tray.
• Do not remove paper from the tray while your machine is printing.
• Flex, fan, and straighten paper before loading.
• Do not use creased, damp, or highly curled paper.
• Do not mix paper types in a tray.
• Use only recommended print media. (See Media Types.)
• Ensure that the recommended side of the print media is facing down in the tray, or facing up in
the Manual Feed Slot, top edge first.
• Do not print duplex output with the rear door open.
Toner Orange Blinking Small amount of toner is left in the cartridge. Prepare a
new cartridge for replacement. You may temporarily
increase the printing quality by redistributing the toner
(See Redistributing Toner.)
On The toner cartridge has almost reached its estimated
cartridge life. It is recommended to replace the toner
cartridge (see Replacing the Toner Cartridge).
Off The toner cartridge is at normal capacity.
WPS Blue Blinking The machine is connecting to a wireless network.
On The machine is connected to a wireless network
Off The machine is not connected to a wireless network.
Power Blue On The machine is in power save mode.
Off The machine is in ready mode or the machine’s power is
off.
ECO Green On Earth Smart mode is on.
Off Earth Smart mode is off.
Status LED Color Status Description
To Next Page
Loading...
Need help?
General