Wireless Connectivity
Xerox® Phaser® 3052/3260
User Guide
14
Wireless Connectivity
This chapter identifies the key settings that you can customize to meet your requirements. Changing
these settings is easy and will save you time when using the machine.
Note: Some options may be unavailable depending on your machine configuration.
The Phaser 3052NI, 3260DI, and 3260DNI are compatible with 802.11 (Wi-Fi
®
) wireless networks.
The location where the machine is installed must be covered by an 802.11 wireless network. This is
typically provided by a nearby wireless access point or router, which is physically connected to the
wired Ethernet that serves the building.
The machine supports connectivity via a wireless only connection if required. The machine will
automatically configure wireless networking when powered on.
Note: The machine will not connect to the wireless network while the network cable is attached.
There are several ways to configure Wireless Connectivity:
•Using CentreWare Internet Services. For instructions, refer to Configure Wireless
Connectivity Using CentreWare Internet Services (Phaser 3052NI, 3260DI, and 3260DNI).
•With the Wireless Setting Program. For instructions, refer to Wireless Setting Program.
Note: Performing the driver installation at this time may aid wireless setup. Refer to Printer
Drivers.
To set the Ethernet Speed using CentreWare Internet Services, refer to Setting the Ethernet Speed
Using CentreWare Internet Services.
Print a Configuration Report
The Configuration Report details the machine software versions and network settings configured for
the machine.
Print a Configuration Report at the Machine
At the printer control panel, press the Cancel button for more than 4 seconds and then release it.
To Next Page
Loading...
Need help?
General