Print-Quality Problems
Phaser® 5550 Printer
6-65
Unfused or Partially Fused Image
The printed image is not fully fused to the paper and easily rubs off.
Possible Causes Solutions
The paper may be damp. Replace the paper.
Heavy or unusual paper may be in the tray. Replace the paper with an approved paper type
then do the following:
■ On the control panel, select Paper
Handling Setup
, and then select Fuser
Configuration
.
■ Adjust the fuser setting for the paper type
selected.
The printer may be located in an environment
with extreme temperature or humidity.
Verify that the printer is located in an
environment with the temperature between
5° and 32°
C (41° and 89° F) and the relative
humidity between 15% and 85%. Move the
printer to a suitable area, away from air
conditioning vents, open loading docks, etc.
The fuser may be defective. Replace the fuser (in the maintenance kit).
To Next Page
Loading...
