Loading Paper
Phaser® 5550 Printer
4-27
5. Push the tray completely into the printer.
6. If prompted on the control panel, press the OK button to accept the paper size and type
that are shown. If you have changed the paper size or type, do the following:
a. Select
Change setup and then press the OK button.
b. Select the paper type, and then press the OK button.
c. Select the paper size, and then press the OK button to save your selection.
7. In the printer driver, select either the paper type or the tray you loaded as the paper source.
Loading Paper in Tray 6 for 2-Sided Printing
Use Tray 6 as a high capacity feeder for 2-sided printing of Letter, A4, Executive, and B5 JIS
paper. Paper can only be loaded long-edge feed in Tray 6.
1. Pull out the tray.
5550-032
5550-112
To Next Page
Loading...
