Xerox Phaser 6360

Printing on Specialty Media
Phaser® 6360 Color Laser Printer
3-45
3. Insert the paper into Tray 1 (MPT), and adjust the paper guides to fit the paper.
■ The paper can be loaded with either the long or short edge entering first, as shown in
the illustrations.
■ The maximum width is 216 mm (8.5 in.).
■ For single-sided printing, if you are using preprinted or prepunched paper, place the
side to be printed facedown with the top of the paper entering the printer first.
■ For automatic 2-sided printing, if you are using preprinted or prepunched paper,
place the first side to be printed faceup with the bottom of the page entering the
printer first.
4. On the control panel, select Change setup, and then press the OK button.
5. Select the paper type, and then press the OK button.
6. Do one of the following:
■ If your custom paper size is listed in the menu, select it, and then press the OK button.
■ If your custom paper size is not listed in the menu, select New Custom Size, and then
press the OK button.
Single-Sided Printing 2-Sided Printing
6360-064
XE
6360-065
Downloaded From ManualsPrinter.com Manuals