Xerox Versant 4100 Press - Page 13

Xerox Customized Envelope Feeder – Problem Solving Guide 2-7
C Feeding Stops (Feeder Models A and B Only)
Did you press the RESET button prior to submitting the job?
N Y
Check the alignment of the Interlock Sensors. Adjust the Interlock Sensors so they are aligned.
The sensors must be touching for the Feeder to operate properly. (For XPF125Axxx and
XPF125Bxxx models only.)
Poorly Aligned Sensors (BAD) Properly Aligned Sensors (GOOD)
Press the RESET button and restart the job.
Does the Feeder stop feeding after just one envelope is fed?
N Y
Check the alignment of the Interlock Sensors. Adjust the Interlock Sensors so they are aligned.
The sensors must be touching for the Feeder to operate properly. (For XPF125Axxx and
XPF125Bxxx models only.)
Poorly Aligned Sensors (BAD) Properly Aligned Sensors (GOOD)
Normal Operation.