Xerox Customized Envelope Feeder – Problem Solving Guide 6-1
Section 6 General Procedures
GP 6.1 Cleaning Feed Belts, Discharge Belts and O-Rings
1. Turn the power switch to O (off) and remove the power cord from the power source.
2. Apply a small amount of isopropyl alcohol to a soft cloth.
3. For belts, use moderate pressure to wipe across one belt at a time while manually rotating it.
Repeat for several rotations of each belt.
4. For O-rings, remove the gate assembly from the gate plate first and then wipe in each direction.
To Next Page
Loading...
