4-2 Xerox Customized Envelope Feeder – Problem Solving Guide
REP 4.4 Separator O-Ring Advancement
Advance the separator assembly O-rings when they show wear. Follow the steps below to access the
O-rings on the Separator:
1. Turn the power switch to the Off position and remove the Feeder power cord from the
power source.
2. Move the Feeder away from the Versant Bypass Tray.
3. Engage the J-Hook to lock the Discharge Assembly of the Feeder in the UP position.
4. Remove the Separator Assembly from the Separator Bracket by pushing down on the
Separator Barrel while lifting up on the Separator Adjustment Knob. Repeat when re-
installing.
To Next Page
Loading...
