Xerox Versant 80 Press - Business Ready Finisher (BR Finisher)

Versant 80 Press
Customer Expectation & Installation Guide
Standard Finisher Plus Staple Tray Capacity by weight and paper finish
Paper type and weight Paper Size
B5 / 7.25 x 10.5 in A4 / 8.5 x 11 in B4 / 8.5 x 14 in A3 / 11 x 17 in
Coated 55-105 gsm Not supported Not supported Not supported Not supported
106-128 gsm 5 5 5 5
129-150 gsm 5 5 5 5
151-176 gsm 5 5 5 5
177-220 gsm 5 5 5 5
221-256 gsm 4 4 4 4
256-300 gsm 3 3 3 3
301-350 gsm Not supported Not supported Not supported Not supported
Interposer
The Standard Finisher Plus includes a standard Interposer, used to insert pre-printed stock into finished sets without having to go through the
print engine. Labels, coated media and envelopes are not supported.
The Interposer is also called the Post-Process Inserter, and depending on the product, it is either Tray T1 or Tray 8.
NOTE: These specifications are the same as the Standard Finisher.
Interposer Capacity by weight and paper finish
Paper type and weight
Paper Size
B5 / 8 x 10 in A4 / 8.5 x 11 in B4 / 8.5 x 14 in A3 / 11 x 17 in
Uncoated 52-80 gsm
200 shts
200 shts 200 shts 200 shts
81-220 gsm
H=22mm (0.87 in)
H=22mm (0.87 in) H=22mm (0.87 in) H=22mm (0.87 in)
Hole Punching
The Standard Finisher Plus offers Hole Punching as a standard feature.
 Holes are created on the trail edge of the sheet.
 Hole punching is not available to the Booklet Tray.
 Hole punch capacity is equal to the regular capacity of the chosen output tray
 For the USA, 2- and 3-hole punching is available; for Europe, 2- and 4- hole punch is available. Stacks can be punched on the left or right side, or
on the top edge
NOTE: These specifications are the same as the Standard Finisher.
Hole Punch Capacity by weight and paper finish
Paper type and weight Paper Size
B5 A4 / .5 x 11 in B4 / 8.5 x 14 in A3 / 11 x 17 in
Uncoated 52-220 gsm Applicable Applicable Applicable Applicable
Coated 106-220 gsm Applicable Applicable Applicable Applicable
Supported Stocks for the
Finishing Transport
When delivering sheets to a connected third-party finishing device, the Standard Finisher Plus can pass
through substrate sizes from 182 mm (7.16 in) to 488 mm
(19.2 in) in the process direction, and 182 mm (7.16 in) to 330.2 mm (13 in) in the cross-process direction,
substrate weights from 55-350 gsm (16 lb. Bond-130 lb. Cover).
Standard Finisher Plus Limitations Productivity may be reduced by up to 50% when running multiple sets of a single sheet job to the Stack Tray,
due to the press being forced to wait while each single sheet set is ejected to the Stacker Tray.
Business Ready Finisher (BR Finisher)
The Business Ready Finisher includes:
 Multi-position Stapling
 Hole Punch