English
Xerox WorkCentre 3550
Quick Use Guide
24
Banner Sheet
The machine can print a banner sheet with every print job. Use the following
instructions to enable or disable the Banner Sheet at the machine.
1. Press Machine Status on the control panel.
2. Press the up/down arrows to highlight System Setup and press OK.
3. Enter the Administrator’s Password using the keypad. The default is 1111.
Note: You may have to press the 1 key several times to enter the ‘1’.
After entering a character press the Right arrow button to enable the
next character to be entered, or wait 2 seconds between presses.
Continue entering characters until the full password has been entered
and press OK.
4. Press the up/down arrows to highlight Machine Settings and press OK.
5. Press the up/down arrows to highlight Banner Sheet and press OK.
6. Press the up/down arrows to highlight Enable or Disable and press OK.
7. Press Stop to save and exit.
To Next Page
Loading...
