Xerox WorkCentre 5019 - Network Environment; Print Feature; Scan Feature

Xerox
®
WorkCentre
®
5019/5021
Network Addendum
6
Network environment
This section describes the environment settings needed to use the machine as a network printer.
Note To connect the machine directly to a computer to use as a local printer, refer to the
WorkCentre 5019/5021 User Guide.
Print feature
The machine can be connected to a network for use as a network printer.
Print from network-connected computers using the TCP/IP protocol.
To use the machine as a network printer, you need to activate the port to use for printing.
• LPD: Activate this setting when using the LPD port.
• Port9100: Activate this setting when using the Port9100 port.
Note This feature is available when the optional Network Print Kit is installed.
For information on how to set TCP/IP, refer to Setting the network environment on page 8.
For information on how to activate a communication port, refer to Activating the communication
port on page 13.
Scan feature
The machine supports the scan feature using the USB interface connection.
Important Scanning through an Ethernet network is not supported.
For more information, refer to the WorkCentre 5019/5021 User Guide.
Network Connection
LPD / Port9100