EasyManua.ls Logo

Xerox WorkCentre 5019 - Notes and Restrictions for Ipv6 Connection

Xerox WorkCentre 5019
50 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Xerox
®
WorkCentre
®
5019/5021
Network Addendum
44
Configuration on the computer
IP addresses are managed for the entire system. Configure the settings only after consulting your
network administrator.
When setting the network such as IP addresses with a host used under the Network Information
Service (NIS), consult your NIS administrator.
While printing
When you change a computer's IP address or a computer name, queries and cancel processes
submitted from the machine are no longer executed correctly. Thus, turn the machine off and on when
there is no print data in the receiving buffer.
Note You can use the machine's control panel to cancel printing of the current print data in the
machine's receiving buffer but not printing of pending print data.
Notes and restrictions for IPv6 connection
This section describes notes and restrictions to observe when using IPv6 connection.
You can only use the following operating system versions to print in an IPv6 environment:
–Windows XP
Windows Vista
Windows 7
Windows Server 2008
Windows Server 2008 R2
Windows 8
Windows Server 2012
Note IPv6 must be installed for PCs with Windows XP.
IPv6-in-IPv4-tunneling in the machine itself is not supported.
Note If IP Mode is set to IPv6, the IPv6-inIPv4-tunneling cannot be performed.
Communication problems may occur when multiple routers exist on the same subnet.
The network settings of the DNS server or a server used by the machine may cause performance
problems when using services in a dual stack environment.
Automatically set IPv6 addresses and IPv6 DNS server addresses may be unavailable addresses.
"Unavailable IPv6 addresses" mean site-local addresses (fec0::) or addresses with the IPv6
documentation prefix (2001:db8::/32).
IPv4 DNS information can sometimes be used directly after machine startup if the IP operation
mode is Dual Stack, DNS information has been set for both IPv4 and IPv6, and the machine is
communicating with a device specified using an FQDN.
The address displayed as the machine's IP address may change.
For example, in Dual Stack mode, either the IPv4 address or IPv6 address may not be displayed, or
a different IPv6 address may be displayed.

Table of Contents

Other manuals for Xerox WorkCentre 5019

Related product manuals