Xerox WorkCentre 5019 - Ethernet (Connectivity > Physical Connections); TCP;IP (Connectivity > Protocol)

Xerox
®
WorkCentre
®
5019/5021
Network Addendum
19
Ethernet (connectivity > physical connections)
Rated Speed
You can set the Ethernet port speed. Select from Auto, 10 Mbps Half-Duplex, 10 Mbps Full-Duplex, 100
Mbps Half-Duplex or 100 Mbps Full-Duplex. (Default: Auto)
MAC Address
The machine's MAC address is displayed.
Apply button
Use to apply changes.
Note Reboot the machine to enable the new settings.
TCP/IP (connectivity > protocol)
IP Mode
You can set the IP operation mode. You can select from Dual Stack, IPv4 or IPv6. The Dual Stack setting
lets you use both IPv4 and IPv6 addresses. (Default: IPv4)
General
•Protocol
• Enabled is displayed.
•Physical Connection
• Ethernet is displayed.
•Host Name
You can set the host name. You can enter up to 1 to 32 single-byte alphanumeric characters or
hyphens.
Note Hyphens (-) cannot be used as the first or last character in the string.
IPv4
–IP Address Resolution:
You can set the method used to acquire the IP Address, Subnet Mask and Gateway Address.
You can select from STATIC, DHCP, BOOTP, RARP or DHCP/Autonet for the address
acquisition method. (Default: DHCP/Autonet)
–IP Address:
You can enter the IP address when STATIC is selected for IP Address Resolution.
•Subnet Mask:
You can enter the subnet mask when STATIC is selected for IP Address Resolution.
• Gateway Address:
You can enter the gateway address when STATIC is selected for
IP Address Resolution.