Xerox WorkCentre 5019 - System Administrator Settings (Security); Support Tab; Support

Xerox
®
WorkCentre
®
5019/5021
Network Addendum
25
– Source IP Mask:
You can set the prefix length of the IP address that is excluded from access. (Default: 0)
• Delete button
You can delete the IPv6 address that is excluded from access by pressing this button.
Apply button
Use to apply changes.
Note Reboot the machine to enable the new settings.
System administrator settings (security)
You can set the system administrator's user ID and passcode.
System administrator settings
• Administrator's Login ID
You can enter the system administrator's user ID (between 1 and 32 ASCII code characters in
length, excludes "+", ";", "<", ">", """, "?", "[", "]", "'", "{", "}", "|", ":". (Default: admin)
• Administrator's Passcode
You can set the system administrator's passcode (between 4 and 12 ASCII code characters or
blank). (Default: 1111)
• Retype Administrator's Passcode
You need to re-enter the system administrator’s passcode that you have entered.
•Maximum Login Attempts
When login attempts using the system administrator’s user ID fail repeatedly, access is denied
when the number of failed attempts reaches the number set here.
Specify a number between 0 and 10. Specify 0 to disable this setting.
The total number of failed authentication attempts is reset when authentication is successful or
the system is restarted. (Default: 5)
Apply button
Use to apply changes.
Support tab
The links to support information is displayed. Link settings can be changed.
Support
Change Settings button
You can change a link to support information by pressing this button.