Xerox WorkCentre 5019 - Setting the Network Environment; Setting the Machines IP Address (Ipv4)

Xerox
®
WorkCentre
®
5019/5021
Network Addendum
8
2. Connect a network cable to the Ethernet interface connector.
Note Prepare a network cable suitable for your network connection. When you replace the
network cable, contact our Customer Support Center.
3. Press the power switch to the On position to turn the power on.
Setting the network environment
This section describes how to make the settings needed to use the TCP/IP protocol.
Note The machine supports IPv6 addresses in an IPv6 network environment. For more
information, refer to Setting the machine's IP address (IPv6) on page 9.
Setting the machine's IP address (IPv4)
To use the TCP/IP protocol, you must set the machine's IP address.
By default, the machine is set to obtain its IP address automatically.
This setting automatically sets the machine's IP address when the machine is connected to a network
containing a DHCP server.
Print the System Settings Report to check whether the machine's IP address has already been set.