Xerox WorkCentre 5019 - Clock and Network Settings; Entering System Administration Mode

Xerox
®
WorkCentre
®
5019/5021
Network Addendum
30
Clock and Network settings
This section describes the procedures for entering/exiting System Administration mode, gives the
procedure to change settings, and describes the clock settings and network function settings you can
change.
Note For System Settings, Account Mode Settings, and Feature Settings, refer to the WorkCentre
5019/5021 User Guide.
Each machine feature is set to factory default (initial) settings, but you can customize these settings to
match your operating environment. You can change these settings in System Administration mode.
Notes
• Some settings cannot be displayed on certain models. An optional component is required. For
more information, contact our Customer Support Center.
• If there are any current or pending jobs you cannot enter System Administration mode.
• While in System Administration mode you cannot receive a print job or start a print or scan
job.
Entering System Administration mode
1. Press and hold the Log In/Out button for more than 4 seconds until the screen below displays.
Log In/Out button