Xerox WorkCentre 5019 - Notes and Restrictions; Notes and Restrictions When Connecting to Internet or Intranet; Notes and Restrictions When Operating from Computers; Notes and Restrictions for Using TCP;IP (Lpd;Port9100)

Xerox
®
WorkCentre
®
5019/5021
Network Addendum
43
Notes and restrictions
This section describes the notes and restrictions to observe when using the machine. For notes and
restrictions on machine use, Copy, Print, and Scan features, refer to the WorkCentre 5019/5021 User
Guide.
Note Scanning through an Ethernet network is not supported.
Notes and restrictions when connecting to Internet or intranet
Internet/intranet connections
Depending on the Web server, server application, proxy server, and firewall, you may not be able to
connect to the Internet or intranet.
To connect to the Internet or intranet using a third party server application, proxy, or firewall, the
following requirements must be met:
• The software must run on Windows XP, Windows Server 2003, Windows Server 2008, Windows
Server 2008 R2, Windows Vista, Windows 7, Windows 8, or Windows Server 2012.
• RFC2617: HTTP Authentication: Basic and Digest Access Authentication must be satisfied. (only
Basic authentication is supported, the other authentications are not supported)
• Supporting the GET/CONNECT/POST methods
CentreWare Internet Services
• Depending on the browser settings, text for language selection may not be displayed correctly.
• The tabs may not be displayed correctly when there are several browsers to access to CentreWare
Internet Services at the same time or condition of the network. In his case, refresh the display.
Notes and restrictions when operating from computers
Supported OS
The supported OS may vary depending on the functions. For more information, refer to the WorkCentre
5019/5021 User Guide.
Notes and restrictions for using TCP/IP (LPD/Port9100)
This section describes notes and restrictions to observe when using TCP/IP (LPD/Port9100).
Configuration on the machine
• IP addresses are managed for the entire system. Configure the settings only after consulting your
network administrator.
• The setting of subnet mask and gateway addresses may be required depending on the network
environment. Consult your network administrator and configure the required settings.