Xerox WorkCentre 5019 - HTTP (Connectivity > Protocol); IP Filtering (Security)

Xerox
®
WorkCentre
®
5019/5021
Network Addendum
23
• End of Job Timeout
You can set the amount of time the machine waits before terminating the connection when
incoming data stops (between 2 and 3600 seconds). (Default: 60)
• PDL Switching
Enabled is displayed.
Apply button
Use to apply changes.
Note Reboot the machine to enable the new settings.
HTTP (connectivity > protocol)
You can set the HTTP protocol.
Configuration
• Connection
Enabled is displayed.
•Physical Connection
Ethernet is displayed.
• Keep Alive Timeout
The keep-alive timeout time is displayed.
• Port Number
You can set the port No. used for HTTP communication (a value between 1 and 65535). You must
set a unique number for each port. (Default: 80)
• Connection Time-Out
Set from 1 through 255 seconds for the connection timeout time. (Default: 30)
Apply button
Use to apply changes.
Note Reboot the machine to enable the new settings.
IP Filtering (security)
You can restrict the supported IP addresses.
IPv4 Filtering
• IP Filtering
You can select Enabled to enable IP Filtering. (Default: Off)