Xerox WorkCentre 5019 - Connecting the Ethernet Cable

Xerox
®
WorkCentre
®
5019/5021
Network Addendum
7
Connecting the Ethernet cable
When connecting the machine to a network, use the Ethernet interface.
The machine supports 100BASE-TX and 10BASE-T Ethernet interfaces.
Note The Ethernet interface is available when the Network Print Kit is installed on the machine.
To connect the Ethernet interface:
1. Press the power switch to the Off position to turn the power off.
Note Check that the machine status diagram display is off.
10BASE-T/100BASE-TX
interface connector