Network Configuration
WorkCentreâ„¢ 5735/5740/5745/5755/5765/5775/5790
System Administrator Guide
133
UNIX
HP-UX Client (Version 10.x)
HP-UX workstations require specific installation steps to communicate with the machine. The machine
is a BSD-style UNIX printer, whereas HP-UX is a System Vstyle UNIX.
Note: All UNIX commands are case-sensitive, so enter the commands exactly as they are written.
Information Checklist
Before starting the procedure, ensure the following items are available or tasks have been performed:
• Ensure that the correct IP Address is being used for the machine. To verify this, print a
Configuration Report from the device.
At the Device:
a. Press the <Machine Status> button on the device.
b. Touch the [Machine Information] tab.
c. Touch [Print Reports].
d. Touch [Print Report].
e. Touch [Close].
The Configuration Report will print. On the report verify the details under Network Setup heading are
correct.
• Ensure the machine is connected to the network with Ethernet cabling.
• Ensure you can PING the machine IP address from the UNIX workstation.
Configure the Client
• Add the machine hostname to the etc/hosts file on the HP-UX workstation or DNS server.
• Ensure that you can PING the machine from the HP-UX workstation, using the hostname found in
the /etc/hosts file.
• Use either the GUI method or the tty Method as follows:
GUI Method
1. Open a command window from the desktop.
2. Type [su] to become super user.
3. Type [sam] to start the System Administrator Manager (SAM).
4. Select the [Printers and Plotters] icon.
5. Select [lp] spooler.
6. Select [Printers and Plotters].
7. Select [Actions: Add Remote Printer/Plotter...].
8. Enter the following information into the Add Remote Printer/Plotter form:
• [Printer Name: printer name]. Where printer name is the name of the queue being created.
To Next Page
Loading...
Need help?
General
