System Timeout
WorkCentre™ 5735/5740/5745/5755/5765/5775/5790
System Administrator Guide
194
System Timeout
This feature resets the system to the default state after a set amount of time elapses without any user
interface activity.
If users do not interact with Internet Services web pages within the time defined, logged in users will
be logged and all unsaved settings will be lost.
When Authentication and/or Accounting is on (a user is logged in) and the System Timeout timer
expires and if no partial job exists, the system shall log the user out (without warning or notification)
and perform a Reset to Default.
At Your Workcentre:
Note: To configure this feature or these settings access the Properties tab as a System
Administrator. For details, refer to Access Internet Services as System Administrator on page 24.
1. From the Properties tab, click on the [Security] link.
2. Select [System Timeout] in the directory tree.
3. The System Timeout page displays. In the Web System Timer area, for [Minutes], enter the time
the system will wait before a logged in user will be logged out. You can enter a time from 6 to
60000 minutes.
4. Click on the [Apply] button.
5. Click on the [OK] button when you see the message “Properties have been successfully
modified”.
To Next Page
Loading...
Need help?
General
