Xerox WorkCentre 7232/7242 System Administration Guide 105
9 TCP/IP (LPD or Port9100)
This chapter explains how to set up the machine to print from a Windows computer
through LPD or Port9100. The following information is provided.
Information Checklist – page 105
TCP/IP (LPD or Port9100) Environments – page 106
TCP/IP (LPD or Port9100) Installation – page 106
Installation Procedure – page 106
Network Communication Setup – page 107
Workstation Setup – page 109
Test Print – page 109
Information Checklist
Before starting these procedures, make sure that the following items are available or
have been performed.
If problems are encountered during machine setup, refer to the Problem Solving
chapter for assistance.
CAUTION: Do not connect the network cable to the machine until instructed to
do so.
Item By
An existing operational network utilizing TCP/IP is required. These
procedures are not designed to install a network.
Customer
Obtain and record the following information:
• IP address
• Gateway address
• Subnet mask (for IPv4) / Prefix (for IPv6)
• Host name
Refer to the glossary for additional information about the Gateway
Address and Subnet mask, if needed.
Customer
Test the machine to make sure that it is installed fully and functioning
correctly.
Customer
Install the print driver. Customer
To Next Page
Loading...
