141
Enable Network Scanning
When you purchase the Network Scanning/E-mail Kit, you will receive the information and hardware
required to install this feature. The Kit contains the Subscriber Installation Module (SIM), and self-
explanatory instructions, used to install the Network Scanning option.
Follow the instructions supplied with the Network Scanning/E-mail Kit to install the S2X card in an available
PCI slot in the network controller, to connect the cable between the S2X card and the device's backplane,
and to use the Network Scanning/E-mail SIM to activate the network scanning feature.
Print a Configuration Report to verify that network scanning (Scan to File) is an Installed Option.
1. Press the [Machine Status] button.
2. Touch [Print Reports].
3. Touch [Configuration Report].
4. Touch [Print Selected Report].
5. Touch [Close]
To Next Page
Loading...
Need help?
General
