7
Introduction: Read Me
Who Should Use This Guide
This WorkCentre 7655/7665/7675 System Administrator’s Guide has been created to assist Experienced
System Administrators in installing this device on a variety of networks. Print out this Read Me, then use
the steps below as your road map to navigate this guide and assure a successful installation.
Steps for installing this device on your network
Refer to the Physical Connection section and follow the steps provided for Power Cable and Ethernet
Cable installation.
Note the helpful information provided on The Welcome Page and Install Wizards in the Power Cable topic
of the Physical Connection section of this guide. This section also points to instructions for printer
connection directly to a workstation through optional USB or Parallel ports, if so desired.
Print a Configuration Report to verify current device settings
Note: A Configuration Report should have printed when the machine was powered off, then on, during
Power Cable and Ethernet Cable installation. If necessary, perform the following steps:
1. Press the [Machine Status] button (on the machine).
2. Touch [Print Reports]. Touch the [Machine Information tab], if Print Reports is not seen.
3. Touch [Configuration Report].
4. Touch [Print Selected Report].
5. Touch [Close].
To Next Page
Loading...
Need help?
General
