58
12. Click [Apply] to accept the changes.
NOTE: The settings are not applied until you restart the machine.
13. Click the [Status Tab] link.
14. Click the [Reboot Machine] button to reboot the machine. The network controller takes approximately 5
minutes to reboot and network connectivity will be unavailable during this time.
15. A Configuration Report should have printed (by default) when the device rebooted. If the report did not
print, refer to the Configuration Report topic in the General Setup section of this guide and follow the
steps provided.
16. Review the settings for Raw TCP/IP Printing under the heading TCP/IP Settings. These settings
should read as follows:
a. Raw TCP/IP Printing Enabled: Enabled
b. Raw TCP/IP Port Number: 9100
Create an IPP Printer at your Workstation
Verify the correct software is loaded
17. At the Desktop, right mouse click the [My Network Places] icon.
18. Select [Properties].
19. Right mouse click on the [Local Area Connection] icon.
20. Click [Properties].
21. Verify that the [Internet Protocol (TCP/IP)] protocol has been loaded.
To Next Page
Loading...
Need help?
General
