KCU105 Board User Guide www.xilinx.com 7
UG917 (v1.4) September 25, 2015
Chapter 1: KCU105 Evaluation Board Features
°
FMC LPC connector (one GTH transceiver)
°
8-Lane PCI Express (eight GTH transceivers)
°
Two SFP+ connectors (two GTH transceivers)
°
TX and RX pair SMA connectors (one GTH transceiver)
• PCI Express endpoint connectivity
°
Gen1 8-lane (x8)
°
Gen2 8-lane (x8)
°
Gen3 8-lane (x8)
• Two SFP+ connectors
• Ethernet PHY SGMII interface with RJ-45 connector
• Dual USB-to-UART bridge with micro-B USB connector
• HDMI codec with HDMI connector
•I2C bus
•Status LEDs
•User I/O
•Program_B pushbutton
•Pmod Headers
• VITA 57.1 FMC HPC connector J22
• VITA 57.1 FMC LPC connector J2
• Power on/off slide switch SW1
• Power management with PMBus voltage monitoring through Maxim power controllers
and GUI, current monitoring via the FPGA SYSMON block
• Single 10-bit 0.2 MSPS SYSMON analog-to-digital converter
• Configuration options:
°
Dual Quad-SPI flash memory
°
USB JTAG configuration port (Digilent module)
°
Platform cable header J3 JTAG configuration port
°
System controller micro-SD card
To Next Page
