Safe Driving
150
3. 3. Pass the top tether of the child safety seat Pass the top tether of the child safety seat
through the headrest. Open the trim lid of the through the headrest. Open the trim lid of the
adjacent upper anchorage, attach the hook adjacent upper anchorage, attach the hook
and loop to the anchorage, and tighten the and loop to the anchorage, and tighten the
tether.tether.
Notes on installing a child restraint Notes on installing a child restraint
systemsystem
Warning
When installing a CRS on the front passenger
seat, the below instructions can be followed if
needed:
●
Adjust the front passenger seat to its fully
rear position.
●
Adjust the front passenger seat as high as
possible to securely install the childsafety
seat.
●
The height of the vehicle seat belt can be
adjusted if necessary to ensure that the
vehicle seat belt passes through the belt
guide correctly on the child seat without
bending.
●
The front passenger airbag must be
activated immediately after removing the
child seat from the seat.
To Next Page
Loading...
