Output Routing
Ganging = 1+3 2+4 *
Aux1&3 Extern 1 Gain
Output Gain = +12.5dB
Use the encoder or BACK and NEXT keys to find the Output Ganging option and press ENTER.
Use the encoder or BACK and NEXT keys to choose the required ganging option and press
ENTER. If the ganging mode has changed, confirm this with a final press of ENTER and the
ganging is complete.
Note that ganging assumes the settings of the lowest numbered channel in the gang is the
initial master channel and so any changes to ganging will immediately copy the settings from
the lowest member in the gang to all other ganged channels.
For example — adding channel 3 to a gang of 1+3 will instantly make channel 3’s settings
identical to channel 1.
Mutes remain unganged at all times (except in bridge mode — see page 43), as does polarity.
Ganged channels are indicated by the EDIT keys illuminating together and the display
showing the member numbers of the gang:
The label shown (“Extern 1”) is always the lowest gang member, no matter which EDIT button
has been pressed in the gang.
Labels can only be changed through remote control software or the DeltaDirect iPad app.
Ganging states are stored in output memories and will be recalled when an output memory is
recalled to either amplifier outputs or auxiliary outputs.
To Next Page
Loading...
Need help?
General
