Store from Amp Outputs *
STORE an Output Memory
103:
STORE an Output Memory
94:LEFT SIDE 6 SUBS ?
Enter Memory Name
94:LEFT SIDE 6 SUBS ?
Storing a Memory…
When a memory is to be stored, the type is first selected (Input, Output, Source or Everything)
and then in the case of an Output memory, this must be further qualified to determine if the
stored data is to originate from the amplifier outputs or the auxiliary outputs.
To store a memory, from the home screen, press MENU, choose the GLOBAL MEMORY
Sub-Menu and press ENTER.
Use the encoder or BACK and NEXT keys to choose either Input or Output memory type as
appropriate and press ENTER.
In the previous example, the extra step is to choose whether to store the four amplifier
outputs’ data, or the four auxiliary outputs’ data. Choose with encoder and press ENTER.
Use the encoder to choose the memory number to use — memories that are already used will
show the current name and a question mark on the bottom line and ask for confirmation if
chosen:
The name may now be edited/entered using a combination of the encoder and the BACK/NEXT
keys to move along the name. Press ENTER when complete, or QUIT to exit.
Memory is then stored, with a confirmation message and the amplifier will return to the
default screen on the selected bank.
To Next Page
Loading...
Need help?
General
