Operating Your Amplifier: System Adjustments
Overview
Under the System Sub-Menu you’ll find all the non-audio features relating to your amplifier’s
operation. As these are self-explanatory, they are summarised in the table below:
System Sub Menu Option What it’s for…
System Status Check firmware version and system information
LCD Contrast Adjust the viewing angle for the display
LED Brightness Adjust the brightness of meters and switch LEDs
Wakeup Time Add a delay before start of audio fade up or keep muted
Output Meter Option Choose if meters should show pre or post mute
Clip Hold Time Set how long a clip or limit condition is held on meters
Filter ‘Q’
Bandwidth Show PEQ filter bandwidth as ‘Q’ or ‘1/Q’ (bandwidth)
Delay Time/Distance Choose to show delay time in metres, feet or time (mS)