2.4 VEHICLE CONNECTION
Insert the Anyscan to the OBD port on the testing vehicle, diagram below shows
the common locations where the OBD port at. The flashlight equipped may help to
locate the OBD port. Red solid light will be shown on the power indicator if the
device is properly connected.
Figure 2-6 locations of OBD port
2.5 BLUETOOTH CONNECTION
Open the Bluetooth setting on your mobile devices, the Anyscan will be discovered
as the ‘serial number’ of the Anyscan. Once the Anyscan is connected to any of the
mobile devices, it will be remembered by that device and automatically connected
to it when next time the Anyscan is connected to the vehicle/power supply. Blue
solid light will show on the Bluetooth indicator after the Bluetooth is successfully
connected.
You are only able to connect the Bluetooth after connecting the Anyscan to the vehicle/power
supply.
To Next Page
Loading...
Need help?
General
