5.8 GEARBOX MATCH
After changing the gearbox or changing the gearbox ECU, you need to use the
gearbox matching function to re-match the engine and the gearbox.
Before resetting the gearbox, please check the gearbox control unit to ensure that there is no
fault code. If there is a fault code, the gearbox memory function cannot be reset. Please road test
after reset.
The operation guidelines of the Gearbox Matching function are shown as
below:
1. Enter the Gearbox matching menu and choose relevant models according to
the vehicle being tested.
2. Enter the Reset adaptive value menu.
3. Turn on the ignition without starting the engine.
4. Read the note and press OK to continue the Gearbox Matching function.
Figure 5-26 Sample of gearbox matching function (screen 1)
5. Wait until the message ‘Successful operation’ popes up.
To Next Page
Loading...
