Xtralis ADPRO PRO E - 6 Technical Data

ADPROPROE by Xtralis Installation Guide
27386_05 37
6 Technical data
Please note that fundamentally, there are 2 different versions:
l Standard version
l High performance – version (H version)
The H version is distinguished by the following enhanced features:
l The housing front pane is not made up of IR-transmissive sheeting, but a silicon-wafer pane which was
developed specifically for this application and is distinguished by its high transmissivity to IR radiation.
l Camera-like look & feel
l Because of its precision optics, its nominal ranges are greater than those of the standard versions
l H-versions include an in-built heating mechanism
l Because of this heating, they can also be used in harsh climatic conditions. The detectors can be used
despite temperature fluctuations because any air condensation that occurs, that could in turn damp
signals due to the very small water droplet formation in the front pane or on the mirror, is counteracted.
l Additionally, there are two freely programmable zero potential relay outputs
The specifications below apply to all ADPRO PRO PIR detectors.
Technical Specifications All ADPRO PROE-detectors
Spectral response 8-14 μm, double filter
Detection speed 0.2 - 5.0 m/s
Sensitivity or range (with ADPRO
PRO-Tool-software)
20-140% (model specific)
Filter (window) Standard version: HDPE filter, IR-transmissive
High performance
H versions:
Silicon wafer (silica glass)
Vandalism detection, housing Misalignment and aperture monitoring
(NC contact 30 V / 100 mA)
Alarm display Internal LED
Alarm outputs 5 outputs per 75 mA max. at 60 V
DC
Communication RS-485, 9.6 kBit/sec
Temperature compensation Full compensation across the entire nominal operating temperature
range
Power supply 10.5 - 30V
DC
, 24V
AC
±15% (without heating)
Current consumption 18 mA @ 12V
DC
, 14 mA @ 24V
DC
Power consumption, heating 0.5 W / ~41 mA @ 12 V
DC
and -40°C (only H versions)
Operating temperature, nominal Standard versions: -20ºC to +60°C
High performance
H versions:
-40°C to +60°C
Cabling (terminal screws) 2 x 4-7 mm (0.16” - 0.27”)
Cable bushing
Cable exterior: Ø: 9 – 14 mm (M16)
Dimensions (L x W x H) in mm 247 x 100 x 104
Installation l Pole installation
l Wall installation
IP protection rating IP65