Xtralis ADPRO PRO E - CT PRO 2 - Wireless Walk Tester

ADPROPROE by Xtralis Installation Guide
27386_05 29
3.3 CT PRO 2 – wireless walk tester
The wireless walk tester CT PRO 2 facilitates precise detector alignment over the entire nominal detection
range. Optical-acoustical displays, as well as an LED bar to display the strength of the signal received at the
detector make this product an absolute ‘must-have’ tool.
The CT PRO 2 consists of a transmitter which is connected via a connection cable to the RS-485 output of
the detector and a mobile battery-operated receiver.
3.3.1 Brief description: CT PRO 2 Receiver
LEDs
l Power: A bright LED indicates that the device is switched on and the battery is okay. A weak or dimmed
LED indicates insufficient voltage.
l Connectivity: This LED shows whether there is successful communication with the transmitter.
l Signal: This LED bar displays the signal strength of the signal received at the tester during a walk test.
Note: Existing CT PRO 2, which are used for the commissioning of the ADPRO PRO-detector series ,
can still be used. Though, the following item must be ordered: Interface adaptor cable PRO E IFC-
RS-485 for PRO E-detector (item code CH12001001).