Yaesu FT-65R/E - Memory Mode - Storage and Recall; Memory Storage and Recall Procedures

MeMOry stOrage
1. Select the desired frequency, while operating in the VFO mode. Be sure to
set up any desired CTCSS or DCS tones, as well as any desired repeater
offset. The power level may also be set at this time, if you wish to store it.
2.
Press and hold in the
F/W key for one second.
3.
Within
ten seconds of releasing the F/W key, you need to make a decision
regarding channel storage. The microprocessor will automatically select the
next-available
“free”

channel

(a

memory

register

on

which

no

data

has

been

stored), so you may not wish to make any change;
if this is the case, pro
-
ceed to step 4. If you wish to select a different channel number into which to
store
the data, press
the
[

] or [

] key
to select the desired memory chan-
nel. You may jump 100 memory channels, if you’re in a hurry (101

201

301
…
) by pressing the
[
#BAND
] key (multiple times, if necessary).
4. Press the F/W key once more to store the frequency into memory.
5.
Y
ou still will be operating in the “VFO” mode, so you may now enter other
frequencies, and store them into additional memory locations, by repeating
the above process.
MeMOry reCall
1. While operating in the VFO mode, press the
[
* V
/
M] key twice to enter the
Memory mode.
2. Press[▲]or[▼]keytoselectthedesiredchannel.
3.
T
o return to the VFO mode, press the
[
* V
/
M] key.
When the radio is already set to the Memory mode, an easy way to recall mem-
ories is to key in the memory channel number, then press the F/W key.
For example
, to recall memory channel #14, press
[
1
]

[
4
]

F/W.
You may also recall the Memory Channel #000 and Programmable Memory
channels (“L1/U1” through “L10/U10.”) using the following numbers: Memory
Channel #000 = “200,” Programmable Memory channels #L1 = “201,” U1 = “202,”
L50 = “209,” and U50 = “210.”
15
MeMOry MOde
FT-65R/E Operating Manual
ApplicationforFCC/IC
FCCID:K6620665X20/IC:511B-20665X20