Yaesu FT-65R/E - Preferential Memory Scan

1. Recall the Memory Channel to be skipped during scanning.
2.
Press the
F/W key, then press the
[
0 SET] key to enter the Set mode.
3. Press[▲][▼]keytoselectSetModeItem“29: SKIP”
4.
Press the
F/W switch momentarily to enable adjustment of this Set Mode
Item.
5. Press[▲][▼]keysoastoselect“SKIP.”thenpressF/W switch.
The current Memory
Channel will now be ignored during scanning and black
color.
6.
If skipped memory select then press
F/W switch, will be not skip during the
memory scanning.
7
W
hen you have made your selection, press the [PTT] switch to save the set
-
ting
andexittonormaloperation.
To re-institute a channel into the scanning loop, select “OFF” in step 5 above (the
“Skipped” channel will, of course, still be accessible via manual channel selec-
tion methods using
[▲]or[▼]key in the MR mode, whether or not it is locked
out of the scanning loop).
Preferential Memory Scan
The FT-65R/E also allows you to set up a “Preferential Scan List” of channels
whichyoucan“ag”withinthememorysystem.Thesechannelsaredesignated
by a blinking “

” icon when you have selected them, one by one, for the Prefer
-
ential Scan List.
Here is the procedure for setting up and using the Preferential Scan List:
1.
Recall the Memory Channel which you wish to add to the Preferential Scan
List.
2. Press the F/W key, then press the
[
0 SET] key to enter the Set mode.
3. Press[▲]or[▼]keytoselectSetModeItem29: SKIP.
4.
Press the
F/W key momentarily to enable adjustment of this Set Mode Item.
5. Press[▲]or[▼]keysoastoselect“ONLY.”
6.
W
hen you have made your selection, press the PTT key to save the settings
andexittonormaloperation.
7.
T
o remove a channel from the Preferential Scan List, just repeat the above
procedure,pressing[▲]or[▼]keytoselect“OFF”instep5above.
In the factory default conguration, you may recall Set Mode Item 29: SKIP
by pressing F/W

[
8
(
P2
)]
.
To initiate Preferential Memory Scan:
1.
Press the
F/W key, then press the
[
0 SET] key to enter the Set mode.
2. Press[▲]or[▼]keytoselectSetModeItem######.
3.
Press the
F/W key momentarily to enable adjustment of this Set Mode Item.
4. Press[▲]or[▼]keysoastoselect“ONLY.”
5.
Press the
PTTkeytosavethesettingsandexittonormaloperation.
20
sCanning
FT-65R/E Operating Manual
ApplicationforFCC/IC
FCCID:K6620665X20/IC:511B-20665X20